CAMS 55

The CAMS 55 design was derived from the unsuccessful CAMS 51 and followed the familiar Chantiers Aéro-Maritimes de la Seine (CAMS) formula of a conventional biplane flying boat configuration with tandem tractor-pusher engines mounted in the interplane gap. The cockpit was open, and there were open gun positions in the bow and amidships. The bow also incorporated an observation balcony with windows sloped to afford a good downward view.

A single prototype was followed by two aircraft to compare different engine installations, one with air-cooled radials and the other a liquid-cooled V engine; in the end, the French Navy ordered some of each. Eventually, 15 escadrilles were equipped with CAMS 55s of various subtypes, replacing the Latham 47 in some units, and in turn being relegated to secondary duties when the Breguet Bizerte became available in 1936. Twenty-nine remained in service at the outbreak of World War II, with the last examples serving with Escadrille 20S in Tahiti until January 1941.

Variants:

55.001 – prototype with Hispano-Suiza 12Lbr engines (one built).

55J – engine test version with Gnome et Rhône licence-built Bristol Jupiter engines (two built).

55H – engine test version with Hispano-Suiza 12Lbr engines (two built).

55/1 – production version with Hispano-Suiza 12Lbr engines (43 built).

55/2 – production version with Gnome et Rhône licence-built Bristol Jupiter engines (29 built).

55/3 – version with all-metal hull for French Navy requirement for long-range flying boat. Prototype destroyed early in test programme (one built).

55/6 – version with all-metal hull and floats, saving 400 kg (882 lb) of structural weight; deemed too expensive to produce (one built).

55/10 – version with geared Gnome et Rhône Jupiter engines and increased fuel tankage (32 built, including four tropicalised machines).
Powerplant: 2 × Gnome et Rhône 9Kbr, 370 kW (500 hp) each
Propeller: 4-bladed fixed pitch
Wingspan: 20.4 m (66 ft 11 in)
Wing area: 113.45 m2 (1,221.2 sq ft)
Length: 15.03 m (49 ft 4 in)
Height: 5.41 m (17 ft 9 in)
Empty weight: 4,590 kg (10,119 lb)
Gross weight: 6,900 kg (15,212 lb)
Maximum speed: 195 km/h (121 mph, 105 kn)
Cruise speed: 150 km/h (93 mph, 81 kn)
Range: 1,280 km (800 mi, 690 nmi)
Service ceiling: 3,400 m (11,200 ft)
Rate of climb: 2.2 m/s (430 ft/min)
Crew: 4
Armament: 4 × trainable 7.5 mm (0.295 in) machine-guns
Bombload: 2 × 75 kg (165 lb) carried under lower wing

55/11 – long-range patrol version (one built).

55/14 – version with all-metal hull (one built).

CAMS 51

The CAMS 51 was a transport flying boat built in France in the mid-1920s. Designed by Maurice Hurel as a private venture by Chantiers Aéro-Maritimes de la Seine (CAMS), it was a conventional biplane with two radial engines mounted in a tractor-pusher installation in the interplane gap. The first flew in 1926.

One example (the 51C) was sold to Aéropostale, which used it for tests in preparation for transatlantic services.

CAMS also built a militarised version as the 51R3 in the hopes of interesting the French Navy in it as a reconnaissance aircraft, but no order was forthcoming.

A final aircraft was built as a record-breaking machine originally designated 51-3 R that broke the world payload-to-altitude record on 18 August 1927 by lifting 2,000 kg to 4,684 m (15,368 ft). This aircraft was later used as a pathfinder for French airmail routes to South America.

CAMS 51C
Powerplant: 2 × Gnome et Rhône 9Aa, 283 kW (380 hp) each
Wingspan: 20.40 m (66 ft 11 in)
Wing area: 115.0 m2 (1,237 sq ft)
Length: 13.78 m (45 ft 2 in)
Height: 5.00 m (16 ft 5 in)
Empty weight: 3,150 kg (6,945 lb)
Gross weight: 5,150 kg (11,354 lb)
Maximum speed: 200 km/h (125 mph, 109 kn)
Range: 100 km (620 mi, 540 nmi)
Service ceiling: 4,600 m (15,100 ft)
Crew: two
Capacity: four passengers

CAMS 51 R.3

CAMS 37

(CAMS 37A model)

For shipborne observation/patrol, CAMS’ bay-windowed 37A first flew in 1926. About 150 were produced in the inter-war years. With its Lorraine 450hp broad arrow V12 and coarse pitch and small diameter pusher propeller it lasted longer than most with one example being operated by the Free-French from Tahiti. It could be operated from land strips when a wheeled main gear was attached, but was not capable of amphibious use since it could neither take off nor land on water in this configuration.

Campbell-Jones Ladybird

Single seat single engined high wing mono¬plane with conventional three axis control. Wing has swept back leading edge, unswept trailing edge and tapering chord; cruciforin tail. Pitch control by elevator on tail; yaw control by fully flying rudder with additional fin; roll control by wing warping; control inputs through stick for pitch/roll and pedals for yaw. Wing braced from below by struts; 100% double surface. Undercarriage has three wheels in tricycle formation; coil spring suspension on nose¬wheel and disc spring suspension on main wheels. Push right go right nosewheel steer¬ing connected to yaw control. Brake on nosewheel. Aluminium tube framework, without pod. Engine mounted at wing height driving tractor propeller.
Although the Ladybird is the first microlight to carry his name Mike Campbell Jones is no stranger to the micro¬light industry, having worked at one time or another for Hiway and Huntair in Britain, and Fulmar and the EMC 2 company in Belgium.
The Ladybird does not set out to be a high performance aircraft, at least not in terms of climb rate and speed. Instead, Mike has tried to create a light, simple machine with a good glide ratio and pleasant handling. The pro¬totype Ladybird was shown at the Long Marston fly in during August ’82 and was generally well received; however it was obviously in need of refinement and since then push rods and bell cranks have re¬placed control cables, the rudder has been down sized to eliminate over sensitivity and a differential movement has been built into the wing warping mechanism, to give the ‘up’ wing more movement than the ‘down’. The Ladybird’s most unusual feature is its wing warping mechanism, however, this mechanism is not just for roll control; a separate lever allows the pilot to twist both wings equally to adjust the speed range, thus permitting the pilot to select a slower stall speed in preparation for a tricky landing.
In 1983, the aircraft was powered by a Hiro engine, but Mike was not satisfied with its reliability and was consider¬ing substituting the 330 Robin for production aircraft.

Engine: Hiro Delta Mk I, 22 hp at 7500 rpm.
Propeller diameter: 54 inch, 1.37m.
Gearbox reduction, ratio 3.0/1.
Max static thrust 130 lb, 59 kg.
Power per unit area 0.16hp/sq.ft, 1.7hp/sq.m
Fuel capacity 4.8 US gal, 4.0 Imp gal, 18.2 litre.
Empty weight 250 lb, 113kg.
Max take off weight 475 lb, 215kg.
Payload 225 lb, 102 kg.
Max wing loading 3.49 lb/sq.ft, 17.1 kg/sq.m.
Max power loading 21.6 1b/hp, 9.8kg/hp.
Load factors +6.0, 3.0 design
Length overall 18.0 ft, 5.50 m.
Height overall 7.4ft, 2.26m.
Wing span 36.1ft, 11.00m.
Chord at root 4.6ft, 1.40m.
Chord at tip 3.0ft, 0.90m.
Dihedral: 2deg.
Sweepback: 7.5deg
Tailplane span 6.3 ft, 1.91 m.
Fin height 2.0 ft, 0.61 m.
Total wing area 136 sq.ft, 12.6 sq.m.
Fin area 1.5sq.ft, 0.14 sq.m.
Rudder area 9.5sq.ft, 0.88 sq.m.
Tailplane area 10.0 sq.ft, 0.93 sq.m.
Total elevator area 22.0 sq.ft, 2.04 sq.m.
Wing aspect ratio 9.64.
Wheel track 5.0 ft, 1.52 m.
Wheelbase 5.5 ft, 1.68 m.
Nosewheel diameter overall 13 inch, 33 cm.
Main wheels diameter overall 13 inch, 33 cm.
Floats, dimensions length 12 ft, 3.7 m.
Max level speed 55 mph, 88 kph.
Never exceed speed 65 mph, 105 kph.
Max cruising speed 50 mph, 80 kph.
Economic cruising speed 45mph, 72kph.
Stalling speed 25 28mph, 40 45kph.
Best glide ratio with power off 13/1 at 45 mph, 72 kph.
Take off distance 150 ft, 45 m.
Land¬ing distance 100ft, 30m.
Service ceiling 3000ft, 910m.
Range at average cruising speed 100 mile, 161 km.

Campbell Cougar

The Campbell Aircraft Company was founded in the late 1950’s to develop and build autogyros and in 1969 began production of the single seat Cricket autogyro. This was later followed by a two-seat project and the construction of a single seat prototype was carried out by Western Airways at Weston-super-Mare Airport in early 1973. Powered by a single Rolls Royce Continental O-240-A 4-cylinder ‘flat-four’ piston engine it first flew in April 1973.

Cricket autogyros were still being manufactured in 2007, and Peter Lovegrove who was the original designer of the Cougar and Cricket was still involved.

Campbell Air Ship / Novelty Air Ship Co Airship

Powered by an Edison electric motor, its 18,000 cu. ft. envelope supplied by Carl E. Meyers, and built a cost of $2500 by the Novelty Air Ship Company of Brooklyn, N.Y., for Professor Peter C. Campbell; the first flight of which was made December 8, 1888 from Coney Island to Sheepshead Bay, piloted by Carlotta the aeronaut – the wife of Carl Meyers. At this time the motive of power is reported to have been bicycle pedals and multiplying gears. The Campbell Air Ship was lost at sea July 16, 1889 while being flown by Professor E. D. Hogan, a Canadian professional aerobat/parachutist, during an exhibition flight originating from the Nassau Gas Works. Intending to make a trip around New York, then to pass over to New Jersey and into the country, five minutes into the flight the 8 foot diameter lower propeller, with which Hogan was to raise and lower the Air Ship gave way and fell to the ground. To make matters worse, it was observed that the steering propellers did not seem to work as no revolutions were discernible, leaving Hogan at the complete mercy of the wind.

Campbell Model F

Designed and built in 1935 by Hayden Campbell in St. Joseph, Missouri, the Campbell F was made of all-magnesium construction and was powered by an 85 hp Ford V-8 automotive engine.The F model was equipped with a tricycle landing gear with steerable nosewheel.

Nicknamed ‘The Flying Easter Egg’, the aircraft was damaged in a demonstration flight and never repaired.

The goal of this side by side two-seater design was a cheap plane for tourism.

This aircraft was seen in a dismantled state in a barn south of Buffalo New York. Prior to that, it had been stored at the Hamburg, NY airfield on North Creek Road.

Engine: 85 hp Ford V-8
Wingspan: 36 ft
Length: 19 ft 4in
Max speed: 190 km/h
Seats: 2 side to side

Campana AN 4 Campana

A composite side by side two seater.

Engine: Limbach L 2000, 80 hp
Wing span: 11.08 m
Wing area: 14.31 sq.m
Empty weight: 255 kg
MAUW: 450 kg
Fuel capacity: 140 lt
Fuel consumption: 12 lt/hr
Max speed: 230 kph
Cruise speed: 210 kph
Minimum speed: 63 kph
Climb rate: 4.3 m/s
Seats: 2
Certification: CASA
Price (1998): 336,000 Fttc
Kit price (1998): 195,000 Fttc