Messerschmitt-Bolkow-Blohm, by 1990, was part of Deutsche Aerospace.
Aircraft
Detroit Aircraft Corp Gull G1

The Gull G1 was developed by Detroit Aircraft as an inexpensive aircraft for the Depression. The Gull is a high wing, cable-braced primary glider.
The Gull is built from wood, with the tail and wing surfaces covered in doped aircraft fabric. The wing is cable braced from a kingpost. The fuselage consists of a simple structure to which the seat is attached. The pilot sits on the completely open seat, with no windshield. Controls are conventional three-axis. The landing gear consists of the bottom of the fuselage shaped into a long wooden skid. Sometimes two small wheels were attached.

On June 20, 1930, the Aeronautics Branch certificated its first glider, the Detroit Gull, Model G-1. The aircraft’s correct designation is not clear. Soaring Magazine calls it the Detroit Gull G1 Primary, while the two Federal Aviation Administration registered aircraft are simply Detroit Gulls. Henley’s ABC of Gliding and Sailflying also calls it the Detroit Gull.

Detroit Aircraft later sold the rights to Stone Aircraft, who sold plans for the aircraft for amateur construction.
One Gull was started before the Second World War by Peter Eyrud of Walla Walla, Washington, but not completed. This aircraft was purchased by Peter M. Bowers who completed and flew it. Bowers documented the aircraft project in an article in the March/April 1957 edition of Soaring Magazine entitled Don’t Build a Primary.
In 1983 two other Gulls were reported to be in storage awaiting restoration.
In May 2011 there were two G1 Gulls registered with the Federal Aviation Administration in the USA. One was in the Kansas Aviation Museum and the other was still registered to Peter M. Bowers, even though he died in April 2003. Soaring Magazine reports that this aircraft too is actually in an unnamed aviation museum.
In August, 2013 one was put on display at the W.L Zimmerman’s Hardware Store, Intercourse, Pennsylvania. This glider has been preserved in original condition from 1931.
G1
Wingspan: 34.5 ft (10.5 m)
Wing area: 170 sq ft (16 sq.m)
Length: 17.5 ft (5.3 m)
Height: 7.0 ft (2.1 m)
Aspect ratio: 7:1
Airfoil: USA 35
Empty weight: 200 lb (91 kg)
Gross weight: 400 lb (181 kg)
Never exceed speed: 103 mph (166 km/h, 90 kn)
Maximum glide ratio: 8:1 at 30 mph (48 km/h)
Wing loading: 2.36 lb/sq ft (11.5 kg/sq.m)
Crew: one
Detroit Aircraft Corp
Formed in 1929 as a parent corporation to take control of several firms hit by the Depression: Lockheed Aircraft Company, Ryan Aircraft Corporation, Eastman Aircraft Corporation, Blackburn Aircraft Corporation, Aircraft Development Corporation, Marine Aircraft Corporation, Parks Airlines Ltd., and the Winton Engine Corporation. The consortium itself failed shortly afterwards.
In 1929 Lockheed merged with the Detroit but After the Great Crash Detroit Aircraft Corporation went bankrupt in 1931 and with it Lockheed.
In 1932, Boston banker Robert Gross led a syndicate that bought and resurrected the company with $50,000. The Electra was a success and the company prospered.
Detroit Aeroplane Co 1910 Monoplane / Miss Detroit

The Detroit Aeroplane Co. displayed a monoplane fitted with the company’s two-cylinder opposed 30 hp engine at the 1910 Philadelphia show, where it was “the hit of the show”. Two of them were sold, one to Atlantic City, where a training school is to be started next summer. It had a main plane with a span of 30 ft and an area 150 sq. ft. Stability was achieved by an arrangement where “the extremities of the wings sections have been cut out and hinged to the rear lateral beam. These float in the air stream in flight, being depressed individually through their attachment to the steering column”, i.e. ailerons… The fuselage was a single seamless steel tube of large diameter, braced with wires over cruciform horizontal and vertical masts.
Detroit Aeroplane Co
74 Crane Ave
Detroit MI
USA
Detroit Mfrs Syndicate.
Desusclade 1910 monoplane

The 1910 Desusclade monoplane was designed and built by Desusclade in France.
Span: 32’2″
de Silva 1909 biplane

This canard biplane, a creation of inventor Abeillard Gomes da Silva, was tested at Tancos, Portugal in 1910. Several unsuccessful take-off attempts were made, before the craft was damaged and then abandoned. It had a wingspan of 6.75 m, weighed 185 kg and was powered by a 28 hp Anzani.

Desert Aviation Staggerlite

Single-seat biplane with forward-staggered wings, the Staggerlite is a reproduction of the Beech Staggerwing. Construction is of wood and polystyrene foam.
Empty weight: 113 kg
Wing span: 5.48 m
Wing area: 11.20 sq.m
Fuel capacity: 19 lt
MAUW: 226 kg
Seats: 1
Kit price (1998): US$2695
Desert Aviation
USA
Offers plans or kits to build Staggerlite single-seat biplane with forward-staggered wings (appeared 1997).
1998:
4704 W.Knollsid St.
AZ 85741 Tuscon
USA
De Schelde Scheldemeeuw
De Schelde produced several designs of their own including the Scheldemeeum, the smallest flying boat in the world.
Seats: 1