Clark Bi-wing Ornithopter

James W. Clark of Bridgewater, Pennsylvania, supposedly tested this machine between 1900 and 1910. It failed to fly, was wrecked, then rebuilt and fitted with its present engine – a 5 hp 2-cylinder Waterman – in 1907.

Currently residing at the Owls Head Transportation Museum in Maine, possibly the oldest full-sized internal combustion engine powered flying machine anywhere in the world.

Clarke Cheetah

Clarke Cheetah Monoplane G-AAJK.

The Clarke Cheetah was a single seat biplane designed in 1929 by J.Clarke with diagonal interplane struts. Powered by a Blackburn engine, it used the lower wings of the Halton Mayfly G-EBOO.

First flown at Brough in 1929 as G-AAJK cn.1.

It was converted in 1930 to a parasol monoplane configuration by A.C.Thomas and partners.

It was broken up in 1937 and donated its wing to the Martin Monoplane G-AEYY.

Wingspan: 29 ft 0 in

Clark & Fitzwilliams Cycloplane

The Clark & Fitzwilliams Cycloplane of 1910 was built in Buffalo, New York, USA. The pedal-powered Cycloplane (sometimes Cycleplane) was 16 feet long spanning 15 feet, weighing about 55 pounds; with approximately 100 square feet of wing surface. Warping wings, front elevator and rear plane with rudder, were all controlled by levers on the frame. It is claimed that flights of 100 feet with a 119 pound pilot were made.

Clancey Skybaby

The Skybaby was a fully-acrobatic, single seat light aircraft with a strut-braced, parasol wing. It was of all wooden construction and covered with lrish linen. The fuselage was a Pratt truss with 3/4 inch square longerons with l/8-inch ply gussets, and weighed just 16 lb bare. The wing employed a Gottingen 426 airfoil, and had a l/2-degree dihedral. The spars were “I” beams with 9/16-inch by 1/2 inch flanges and l/8-inch ply webs. The aircraft had a divided undercarriage with hard tyres, and a tailskid. Before long, the main wheels were replaced with balloon tyres on 5-inch by 4-inch hubs (the same as the tailwheel on Kingsford Smith’s Lockheed Altair).
The Henderson engine, in it’s original side valve configuration, ran at its maximum of 3,000 rpm and suffered overheating problems. Bill Clancy replaced the top half of the engine with new cylinders and alloy pistons, increasing the bore by 9/16 inch to 3-1/8-inch Overhead valves of increased diameter were fired in well finned heads cast in bronze for better heat dissipation and to eliminate the need for valve seat inserts.
A full dual ignition system was fitted and, in its modifed form, the engine delivered 38 brake horsepower at 2550 rpm The compression ratio was increased to 5:1 and it cruised smoothly at 2200 rpm. An extension shaft was bolted to the crankshaft flywheel flange. This shaft was tapered to fit the propeller hub (which was turned down from a Model T Ford rear wheel hub) and carried a shoulder to accommodate a ball thrust bearing in the nose cone, which was fabricated from mild steel sheet. Later models had a Praga “B” 40hp flat twin engine.

Gross-Weight 560 lb
Empty Weight 330 lb in original form 350 lb when modified
Span 25 feet 6 inches
Length 16 feet 2 inches
Wing Area 104 square feet
Wing Loading 5.4 Ib/sq.ft
Span Loading 22.2 Ib/ft
Power Loading 14.7 Ib/hp
Cruising Speed at 2200 rpm 55 mph.
Stalling 8peed 30 mph.
Fuel 31/2 Imp Gals at 13/4 Imp gph.
Propeller 60 inch by 36 inch
Differential brakes, 5-inch by 4-inch tyres, coil springs in telescopic landing gear legs.

CKD-Praga E-114 Air Baby / E.115 / Hilton Praga

The 40 hp Praga B powered prototype, OK-PGA, first flew in Seqtember 1934 and was Praga’s first civil project.
Sixty-three were built.

Following a demonstration tour in the UK in 1935, F.Hills & Sons on Manchester, acquired a licence to build the E.114 as the Hillson Praga. The first Hills & Sons Ltd licence-built Praga E.114 was sold to Australia, and the second registered G-AEEU became the company’s demonstrator in April 1936. Total production by Hills amounted to twenty-eight aircraft, plus seven uncompleted during 1936 and 1937, selling for £385-435.

Praga E-114 Air Baby

In 1936 H.L.Brook set a new Lympne to Cape Town record of 16 days in one of the British built examples.
The E.114bis was fitted with a 65 hp Praga D engine. The prototype E.114bis, OK-PGF, was flown before the Second World War, as was the E.115, an improved version with a shorter wing.

After the war, the Air Baby was relaunched as the E.114D.

CKD-Praga E.114 Air Baby
Engine: Praga B, 29 hp
Length: 21.654 ft / 6.6 m
Wingspan: 36.089 ft / 11.0 m
Wing area: 163.613 sqft / 15.2 sqm
Max take off weight: 1080.5 lb / 490.0 kg
Weight empty: 639.5 lbs / 290.0 kg
Max. speed: 94 kts / 175 km/h
Cruising speed: 79 kts / 147 km/h
Service ceiling: 11483 ft / 3500 m
Wing load: 6.56 lb/sq.ft / 32.00 kg/sq.m
Range: 297 nm / 550 km
Crew: 2

CKD-Praga E.114 Air Baby
Engine: Praga D 1, 75 hp.

E.114bis
Engine: 65 hp Praga D

CKD-Praga E-111 / BH-111           

The E.111 (or BH.111) of 1932 was a two seat low wing monoplane tourer powered by a 110 hp de Havilland Gipsy III engine.

A two-seat lower-wing strutted type used by Flying Clubs. The BH-111 had wooden wing and tailpane covered by plywood, and tube framed control surfaces by fabric. The wood-framed fuselage was covered by plywood and fabric. Sheet metal plate cowling. Fixed undercarriage, wooden two-blade propeller.

One built in 1932 for Air Racing with rearwards folded wings.

Engine: de Havilland Gipsy III, 110 hp
Wingspan: 10.5 m
Length: 7. 4 m
Empty weight: 470 kg
Maximum speed: 230 kph
Climb 3000m: 15 min 45 sec