In 1931 Joe W Wilbur of Exeter NH., USA built a two place, open cockpit, monoplane N998M c/n M-2A. Powered by an 80hp Anzani, it was sold on 15 March 1937 and relocated in New Jersey. It was scrapped on 17 March 1938.
Author: Terry
Wilbur, Joe W
Exeter NH.
USA
Airplane builder circa 1931.
Wight Gliding Club
A primary type glider was built by the Isle of Wight Gliding Club in 1931.
A second machine was built in 1946 using the remains of Spartan Arrow G-AAWT c/n 51 and Spartan Three Seater II G-ABAZ c/n 53.
Wight Aviation Ltd
UK
Aviation department of J. Samuel White under Howard T. Wright, who joined company in 1912. Employed double cambered aerofoils on early designs. Built training and operational seaplanes for Admiralty, a twin-engined torpedo bomber in 1915 and an experimental single-seat quadruplane.
Wigal Autogyro

In 1964 Fritz Wigal built an experimental open-frame, single place, autogyro, N3W. The engine could be pivoted to direct prop blast against a 4-bladed stub rotor located above the main rotor.

Engine: McCulloch O-100, 72hp
Rotor diameter: 20’0″
Empty weight: 320 lb
Gross weight: 570 lb
Useful load: 250 lb
Max speed: 75 mph
Cruise speed: 60 mph
Min speed: 15 mph
Take-off run: 100 ft
Seats: 1
Wigal, Fritz
Jackson TN.
USA
Autogyro builder circa 1964.
WNF Wn 16 / Meindl-van Nes A.XV / Meindl M.15

The WNF Wn 16, designed by Erich Meindl in 1937-1938, originally built as the Meindl-van Nes A.XV (aka Meindl M.15), was an Austrian experimental aircraft built in the late 1930s for tricycle undercarriage research. It was a swept wing tandem two-seater, with a pusher configuration engine and twin-boom fuselage. Its cantilever low wing had straight edges and 18.33° of sweep at quarter chord. The wing was in three parts, with a twin spar, steel tube framed centre section welded to the central fuselage which supported the tailbooms on its upper surfaces at their outer ends. The ribs were also formed from steel tube. The forward part of the centre section was plywood covered, with fabric aft. The outer wing panels were ply covered, each with a single wooden single spar. There was a split flap over the whole centre section trailing edge and slotted ailerons which filled the trailing edges of the outer panels.

The short fuselage was also a welded steel tube structure, alloy skinned front and rear but with a fabric covered central section that contained the tandem seats under a continuous, multi-framed canopy which merged into the rear fuselage. The Wn 16’s pusher configuration, 37 kW (50 hp) Salmson 9Ad nine cylinder radial engine was installed within a Townend ring cowling at the rear of the fuselage beyond the wing, driving a two blade propeller. The Wn 16 was later re-engined with a 45 kW (60 hp) Walter Mikron.

The Wn 16’s tail-booms were wooden monocoques. The rectangular tail-plane and elevator was on top of them, with oval vertical tails acting as end-plates; the fins had ply covered wooden frames and the rudders had fabric covered steel frames.
Its tricycle gear was fixed, all units with bungee cord shock absorbers. Both legs and wheels were enclosed in streamlined fairings. The nosewheel was steerable via the rudder pedals.

After the Anschluss of Austria, it was further developed by Wiener Neustadt Flugzeugwerke (WNF). The Wn 16 flew for the first time on 23 September 1939, carrying on board the German registration code D-ECAB. Development continued into World War II and the first flight with the Walter engine was on 7 August 1942.
The aircraft was tested in Germany, where it was later re-equipped with the Walter Micron engine (60 hp). The WN-16 successfully flew until the autumn of 1942, and then it was transferred to the Technical School in Stuttgart for further tests. There it remained until September 1944, until it was destroyed during an air-raid.
Engine: 1 × Salmson 9Ad, 37 kW (50 hp)
Propeller: 2-bladed
Length: 7.27 m (23 ft 10 in)
Wingspan: 9.84 m (32 ft 3 in)
Height: 1.80 m (5 ft 11 in)
Wing area: 13.50 m2 (145.3 sq ft)
Empty weight: 350 kg (772 lb)
Gross weight: 550 kg (1,213 lb)
Fuel capacity: 38 l (8.4 imp gal; 10 US gal)
Maximum speed: 160 km/h (99 mph; 86 kn) at sea level
Cruise speed: 145 km/h (90 mph; 78 kn)
Range: 400 km (249 mi; 216 nmi)
Service ceiling: 2,800 m (9,200 ft)
Rate of climb: 2.2 m/s (430 ft/min)
Landing speed: 65 km/h (40 mph)
Crew: Two
Wiener-Neustadter / WNF
Wiener-Neustadter Flughafen Betriebs GmbH
Wiener-Neustadter Flugzeugwerk GmbH
Germany
Originally Wiener-Neustadter Flughafen Betriebs GmbH, after the Anschluss of 1938 was amalgamated with Hirtenberg, whose manufacturing department it absorbed under the name Wiener-Neustadter Flugzeugwerk GmbH. Light two-seat biplane in production 1937, later undertook subcontracts on Bf 109. In 1943-1944 built the world’s first tip-jet helicopter, designed by team under Friedrich von Doblhoff. Four built and tested. Conventional piston-engine provided compressed air which, mixed with fuel, was fed to tip-mounted combustion chambers through rotor blades. System adopted by other designers.
Wiener Karroserie Fabrik
Austria
Built an experimental fighter in 1918.
Wiencziers Renneindecker

Built in Germany, the 1911 Eugen Wiencziers Renneindecker a very advanced monoplane with a very sleek fuselage which consisted of a metal tube only. The two wheel undercarriage could be folded back to the fuselage. The machine was intended as a two-seater, where the pilot sat enclosed and the passenger sat in a saddle just at his back on the steel fuselage, just like horse riding.