Germany
Adlerwerke vorm Heinrich Kleyer AG. was formed at Frankfurt am Main in 1934 to take over Frankfurter Flugzeugbau Max Gerner GmbH. Made low-cost, low-powered all-metal light aircraft with Gerner engines.
Author: Terry
Kitty Hawk Cora

Kitty Hawk started flight testing of the Cora aircraft in California and New Zealand in 2017. The Cora is a two-seat autonomous aircraft with 12 lift propellers and a pusher prop.
Kitty Hawk Heaviside

Kitty Hawk revealed on 3 October 2019 that they had been secretly developing a single seat electric aircraft known as the Heaviside. The Heaviside features a front wing with two propellers, six propellers on the main forward swept wing, and a fairly conventional empennage. The propellers are all behind the wings and tilt downward for vertical flight. Later in October 2019, a software timing error lead to a crash of the Heaviside during flight testing.
Kitty Hawk Flyer Gallery
Kitty Hawk Flyer

The Kitty Hawk Flyer flying car startup Google’s Larry Page is backing was first publicly demonstrated in April 2017. An aerospace engineer working for Silicon Valley company called Kitty Hawk piloted the Flyer above a lake about 100 miles north of San Francisco. It is an open-seated, 220-pound Flier with room for one person, powered by eight battery-powered propellers that howled as loudly as a speedboat.

The Flyer one-seat, propeller-driven vehicle is meant for a short flight across lake when you’re at the cottage, not commuting to work. During his test flight, Cameron Robertson, the aerospace engineer, used two joystick-like controls to swing the vehicle back and forth above Clear Lake. The flight, 15 feet above the water, circled over the lake about 20 or 30 yards from shore, and after about five minutes Mr. Robertson steered back to a floating landing pad at the end of a dock. The flyer is controlled by two handlebars and what looks like a giant touchscreen. It travels at up to 25 miles per hour at a max of 15 feet above water.

The vehicle is designed to fly above fresh water with two pontoons at its bottom. The prototype Kitty Hawk is showing off “looks and feels a lot like a flying motorcycle,” according to Cimeron Morrissey, who tested it.
They are flying under a special Federal Aviation Administration category for ultralight aircraft that does not require a pilot’s license and is intended for recreational flying in uncongested areas. To add an extra margin of safety, the Kitty Hawk engineers are sticking to flying over open water.

Kitty Hawk
The Kitty Hawk Flyer is just one flying vehicle being worked on by the Larry Page-backed startup. Page has reportedly invested more than $US100 million into Kitty Hawk and its other division, Zee Aero. Both organisations have registered to test a number of different aircraft, from gliders to sailplanes.
The goal of Kitty Hawk and Zee Aero is to one day reinvent personal transportation. Both divisions have roughly 100 employees combined. The CEO of Kitty Hawk is Sebastian Thrun, cofounder of Udacity and the father of Google’s self-driving car project.
The Kitty Hawk focus on over-water flights is intentional – it’s meant to reassure Federal Aviation Administration officials worried that unlicensed pilots will be flying over populated areas. The company wants to work with the FAA to enable more ambitious vehicles, but it would rather play it safe in the early stages.
Kinney Hot Rod Helicopter / HRH

This helicopter was designed, completed, and flown in one year, one month, one week and one day.
It’s named the Kinney HRH (Hot Rod Helicopter) because of the lack of doors and hood and an air cleaner from a dual quad setup. The helicopter is small enough to fit in a home garage, and the counter-clockwise rotation of the Waitman blades is the same as standard America helicopters.
The HRH uses a 165 hp 4-cycle, 4 cylinder Subaru. It employs a computer-controlled fuel-air mixture, redundant fuel pumps, and multi-port fuel injection. It uses regular gasoline. The rotor head provides full cyclic and collective pitch, with an electronic system for maintaining rotor speed. The main blades are constructed of composite materials and the tail rotor is shaft driven.
The fully enclosed composite cabin features a fully equipped panel with both digital and analog instrumentation; a vinyl-covered seat with a “crumple-zone” support; a 4-point aircraft seat belt; and a tinted polycarbonate windshield. Addition of doors and a catalytic heater provide year-round comfort.
The powder-coated airframe is formed of aircraft-grade 4130 chromemoly steel, the primary structure both welded and bolted together with aircraft hardware. Most of the aluminum parts are black anodized.
Engine: Subaru EJ-25, 165 hp
Cruise speed: 80-90 mph
Empty weight: 1000 lbs
Useful load: 350 lbs
Gross weight: 1,350 lbs
Main rotor diameter: 25 ft
Main rotor chord: 8 in
Tail rotor diameter: 46 in
Length: 20 ft
Height: 7.25 ft
Width: 5.55 ft (175 cm)
Fuel capacity: 18.5 USgal.
Main rotor RPM: 520
Tail rotor RPM: 2,900
Endurance: 2 hours
Top speed: 103 mph
VNE: 115 mph
Blade: Waitman composite
Tail rotor chord: 4.5 in
Kinney

Bob Kinney, designer/builder of the HRH, considers himself a practical “electro-mechanical applicationist.” Bob was born in a small town in Connecticut where, as a young boy, he and some friends would visit a nearby factory that was manufacturing curious rotary-wing machines. Looking back, Bob is convinced that the man with the distinctive Russian accent that continually chased him and his friends away from that factory was Igor Sikorsky—father of the modern helicopter—and only later understood that those curious machines were helicopters.
2002: 221 Fordney Rd, Lancaster, PA 17601, USA.
KLN VL-3

The VL-3 is an ultralight, single-engine, low-wing aeroplane of classical design with a bow-type retractable or fixed landing-gear and two side-by-side seats. The plane has been certified according to regulation UL-2 of the Amateur Aeronautical Association of the Czech Republic for maximum take-off weight (MTOW) of 450 kg.
Harmonious aerodynamic shape and excellent flying performance make the aeroplane suitable for touring or recreational flying.
The VL 3 is being certified in UL catagory for MTOW 450 kg and for MTOW 560 kg according JAR – VLA.
The KLN VL3 airplane is manufactured by Karel Klenor – KLN, Choceň, Czech Republic.
Stall: 35 kt / 40 mph / 65 kmh
Cruise: 119 kt / 137 mph / 220 kmh
VNE: 162 kt / 186 mph / 300 kmh
Empty Weight: 275 kg / 606 lbs
MTOW Weight: 450 kg / 992 lbs
Climb Ratio: 1200 ft/min / 6 m/s
KLN – Karel Klenor
Karel Klenor – KLN, Choceň, Czech Republic.
LSA builder

