Carter 1911 biplane

In the UK in 1911 Mr. Carter was out on the new machine and with the engine running fairly well, the machine made a few hops. The machine is of the biplane type of very short span, with the upper planes of slightly greater span than the lower ones. There is no elevator in front, but that position is occupied by the engine and propeller. The engine is an 8-cyl. made by the Nonpareil Motor Fitting Co. at Birmingham. At present it gives about 60-hp, but when properly tuned up it is expected to reach about 80-hp Mr.Carter succeeded in getting the biplane off the ground for short distances.

Mr. Carter was also out with his biplane after having made a few alterations to the tail. The machine rises very rapidly, in one case getting off the ground in 15 ft. but no extended flights were made owing to the fact that the engine was not running up to form.

Carpenterie M 81 Butterfly

The M 81 uses mixed wood and steel construction, all covered in heat-shrunk Dacron.

Engine: Rotax 912, 80 hp
Wing span: 9.6 m
Wing area: 15.5 sq.m
MAUW: 450 kg
Empty weight: 255 kg
Fuel capacity: 40 lt
Fuel consumption: 15 lt/hr
Max speed: 150 kph
Cruise speed: 120 kph
Minimum speed: 65 kph
Climb rate: 3 m/s
Seats: 2
Price (1998): 30,000 DM
Kit price (1998): 20,000 DM

Carma VT-1 Weejet / Dale Air-Engineering WEEJET 800

In the early fifties Harold Dale played with the idea to design the ideal jet trainer: seating trainee and instructor side-by-side in front of the wing for clear visibility all around. It should have a slow landing speed and a comfortable cruising speed of 350 mph. The plane Harold had in mind was a mid-wing cantilever monoplane of aluminium alloy structure, with slotted flaps, leading edge intake ducts, semi-monocoque fuselage, upwards opening doors, butterfly tail unit and retractable tricycle landing gear.

Harold Dale was a project engineer with North American working on the F-100, so his ideal plane had to be designed in the spare time. He had assistance from his wife Eleanor who also had an engineering degree, handling much of the mathematics, administration, etc.

The name chosen was the WEEJET 800 (WE=Harold and Eleanor), the 800 meaning the power class of the licence built Turboméca Marboré II engine of 880 lb thrust.

In February 1952 Dale Air-Engineering (Torrance, California) and the WEEJET 800 were official registered and the first material was submitted to the CAA West Region Administration. It was the first jet aircraft in the small plane field submitted to the CAA, who followed every phase of the two and a half years of design and evaluated all data during development.

In 1954 a local aircraft parts manufacturer (Carma Manufacturing Co) heard of the design and got involved in the project in two ways: he supplied the hydraulic shock absorber struts and offered to built the aircraft in his plant in Tucson, Arizona. Now it became feasible to produce and market the aircraft. Construction started at Tucson in the second half of 1954 and five people worked one and a half years on it.

The prototype (N8209H) conducted its 20 minutes first flight on Good Friday March 30, 1956, with Harold Dale at the controls. During the following weeks further test flights were made by another pilot, except for the spin tests, these were performed by USAF-pilot Doneby; the aircraft handled and performed well.

During 1956 the US Navy had become interested in jet trainers and the WEEJET was to be in their evaluation. Therefore all data had to be available before the end of the month and the aircraft was to be flown to Patuxtent, Maryland on April 29. On April 28 1956 disaster struck: during the final spin test the pilot inadvertently activated the trim tab into full nose-down position. The pilot lost control while trying to recover and had to bail out, the aircraft crashed and burned. Later data was found thrown clear of the wreckage, showing the spin tests were a complete success.

All following data was issued on April 25, 1956 in a proposal to the US Navy for the production version. The designation was Carma WEEJET TRAINER.

Gallery

Carma VT-1 WEEJET
Type: Two side by side seat primary jet trainer
Engine: Continental J69-T-9 (Marbore II), 920 lb (417 kg) s.t.
Wingspan: 28 ft 0 in (8.53 m)
Length: 24 ft 6 in (7.47 m)
Height: 6 ft 8 in (2.03 m)
Wing area: 150 sq.ft (13.94 sq.m)
Empty Wt: 2,481 lb (1,125 kg)
Max T/O Wt: 4,541 lb (2,060 kg)
Max speed: 334 mph (537 km/h) at 15,000 ft (4,570 m)
Cruise speed: 208 mph at 25,000 ft
Max climb: 2,200 ft (670 m)/min
Service ceiling: 35,000 ft (10,670 m)
Endurance: 1.72 hr at sea level

Carlson Sparrow

Sparrow II

The Carlson Aircraft Sparrow Ultralight is a three axis aircraft conforming to FAA 103 regulations.
The Sparrow II is a two seat version of the Sparrow ultralight with optional folding wings.

Gallery

Sparrow II
Engine: Rotax 582, 66 hp.
Speed max: 130 mph.
Cruise: 110 mph.
Range: 300 sm.
Stall: 36 mph.
ROC: 1750 fpm.
Take-off dist: 75 ft.
Landing dist: 150 ft.
Fuel cap: 10 USG.
Weight empty: 510 lbs.
Gross: 1050 lbs.
Height: 7.75 ft.
Length: 18 ft.
Wing span: 31.5 ft.
Wing area: 140 sq.ft.
Seats: 2.
Landing gear: nose wheel.

Sparrow II XTC
Engine: Subaru, 82 hp.
HP range: 66-85.
Speed max: 130 mph.
Cruise: 110 mph.
Range: 400 sm.
ROC: 1100 fpm.
Take-off dist: 150 ft.
Landing dist: 250 ft.
Service ceiling: 13,000 ft.
Fuel cap: 22 USG.
Weight empty: 600 lbs.
Gross: 1250 lbs.
Height: 7.75 ft.
Length: 18 ft.
Wing span: 31.17 ft.
Wing area: 140 sq.ft.
Seats: 2.
Landing gear: nose wheel.
Optional Continental C-85 or Rotax 912 engine.

Sparrow Sport Special
Engine: Rotax 503, 52 hp.
Speed max: 120 mph.
Cruise: 85 mph.
Range: 300 sm.
Stall: 31 mph.
ROC: 1750 fpm.
Take-off dist: 85 ft.
Landing dist: 175 ft.
Service ceiling: 12,000 ft.
Fuel cap: 10 USG.
Weight empty: 360 lbs.
Gross: 710 lbs.
Height: 5.3 ft.
Length: 16.8 ft.
Wing span: 26.8 ft.
Wing area: 117 sq.ft.
Seats: 1.
Landing gear: tail wheel.

Sparrow Ultralight
Engine: Rotax 277, 28 hp.
Wing span: 30.2 ft.
Wing area: 120 sq.ft.
Length: 16.75 ft.
Height: 6.75 ft.
Weight empty: 115 kg / 254 lbs.
MTOW Weight: 229 kg / 504 lbs
Fuel cap: 5 USG.
Cruise: 50 kt / 58 mph / 93 kmh.
Range: 200 sm.
Stall: 26 mph / 23 kt / 42 kmh
VNE: 55 kt / 63 mph / 101 kmh
ROC: 750 fpm.
Take-off dist: 140 ft.
Landing dist: 195 ft.
Service ceiling: 10,000 ft.
Seats: 1.
Landing gear: nose wheel.

Carlingford Aërial Chariot / Aerhedon

In 1856 Godwin Swift of Kilkenny, Ireland, aka Viscount Carlingford patented an aeroplane both in England and France, resembling in outline a falcon gliding downward with partially closed wings, described by the inventor as follows: “The aerial chariot in form is something in the shape of a boat, extremely light, with one wheel in front and two behind, having two wings, slightly concave, fixed to its sides”. “A tail can be raised and lowered at pleasure by means of a cord. The chariot is drawn forward by an ‘aerial screw’ in front thereof, which screws into the air at an elevation of 45°, turned by means of a winch acting on three multiplying wheels.” The machine was built and tested by swinging it from a rope. The propeller and a wheel are preserved at the Rothe House Museum of Kilkenny.