Main Menu

Bristol Hydra / Double Octagon


It appears the Hydra (also known as the Double Octagon) was built as a "backup" design in case the newer sleeve valve engines being designed by Roy Fedden at the same time proved unworkable. Design of the Hydra was led by Frank Owner, who built an experimental V-4 design to test a new twin overhead cam design, a first for Bristol engines which normally used pushrods and rockers. When the V-4 ran successfully, it seems they used four such engines connected to a common crankcase to produce the Hydra.

The cams were operated by rotating shafts leading from the crankshaft at the back of the engine to the top of each cylinder row. The shaft was directly geared to one of the two camshafts, using another driven shaft to transmit power to the second camshaft on the "other side" of the cylinder heads. The arrangement was somewhat complex, but no more so than a pushrod-based system. A side-effect of the use of the overhead cams was that the cylinders were "in-line", whereas radials typically rotated the second bank of cylinders in relation to the first in order to expose them more fully to the airflow for cooling.

The Hydra had only two valves per cylinder limiting volumetric efficiency. It is generally difficult to properly arrange pushrods for four valve operation in a multi-row radial engine, some of the rods would have to exit the crankcase between the cylinders where there is little room or spare strength. This difficulty was one of the reasons that led to Fedden's work on the sleeve valve. This is not so much of a problem on an in-line design, and is one of the reasons in-lines of the era were able to compete in performance terms with the generally much simpler radials. The use of the overhead cams on the Hydra avoided this problem as well.

Only two Hydra's were built. First run in 1931, one was test flown on the Hawker Harrier, and suffered severe vibration at critical RPMs. In the end, Fedden was able to develop the sleeve valve into a superb series of engines, and the Hydra is almost forgotten.

Hydra
Type: 16 cylinder, twin row, air cooled radial engine.
Bore: 5.0 in (127 mm)
Stroke: 5.0 in (127 mm)
Displacement: 1,570 cu in (25.7 L)
Length: 57 in (1448 mm)
Diameter: 46.5 in (1181 mm)
Dry weight: 1,500 lb (680 kg)
Designer: Roy Fedden
Valvetrain: Double overhead camshaft
Supercharger: Medium supercharged
Fuel type: DTD 134 petrol
Cooling system: Air cooled
Reduction gear: Epicyclic geared, reduction ratio 0.424:1, left hand tractor
Power output: 850 hp at 3,000 rpm
Compression ratio: 6:1
Power-to-weight ratio: 0.56 hp/lb

 

 


Copyright © 2017 all-aero. All Rights Reserved.
Joomla! is Free Software released under the GNU General Public License.