Main Menu

MVP.Aero Inc Model 3
 
 MVP-3-01
 
Designed by Mike Van Staagen, the MVP Model 3 is a prototype American "triphibian" light-sport aircraft, displayed in mockup form in 2014. The aircraft is under development by MVP.Aero Inc. of Delaware.
 
The MVP Model 3 is designed to operate on land, water, snow and ice. The floor panels can be rearranged to accommodate fishing or camping. The design will be marketed in several versions, including the E-AB, E-LSA, and S-LSA. The aircraft is a two-seats in side-by-side configuration with a pusher propeller and folding wings, which are constructed with carbon-fiber composite spars and covered with fabric. The balance of the airframe is constructed from a combination of carbon fiber and fiberglass. Electric thrusters help the aircraft manoeuvre in the water.
 
The design allows the canopy to be raised on a four bar system to sit above the engine cowling. This leaves the cockpit area open for fishing from and can also allow mounting of a tent for camping, with the floor panels inserted. With the canopy fully open the engine can still be run for water maneuvering.
 
The unit cost was US $169,000 as an Experimental and $189,000 as S-LSA.
 
Variants:
Model 3 E-AB
Model 3 E-LSA
Model 3 S-LSA
 
MVP Model 3
Engine: 1 × Rotax 914, 115 hp (86 kW)
Wingspan: 36 ft 0 in (10.97 m)
Length: 23 ft 9 in (7.24 m)
Length wings folded: 8.1 m (26 ft 7 in)
Width: 8 ft 0 in (2.44 m) wings folded
Fuel capacity: 26 US gal (22 imp gal; 98 l)
Cruise speed: 104 kn (120 mph, 193 km/h) at sea level
Stall speed: 41 kn (47 mph, 76 km/h) with full flaps
Rate of climb: 1,000 ft/min (5.1 m/s) at sea level
Wing loading: 11 lb/sq ft (54 kg/sq.m)
Crew: one
Capacity: one passenger
 
 
 
 


Copyright © 2019 all-aero. All Rights Reserved.
Joomla! is Free Software released under the GNU General Public License.